This warranty shall expire two years after shipping date for DOOR-GARD keypads.Įxcept as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without limitation to, the condition of its products, their merchantability, or fitness for any particular purpose. Connect the positive (+) lead of your power supply to the terminal strip (TS1) +V input. IEI will not be liable to the purchaser or anyone else for incidental or consequential damages arising from any defect in, or malfunction of, its products. IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the defective product or part when sent to IEI’s facility (freight and insurance charges prepaid), after first obtaining IEI’s Return Merchandise Authorization. IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God. (IEI) warrants its products to be free from defects in material and workmanship, when they have been installed in accordance with the manufacturer’s instructions, and have not been modified or tampered with. On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included).To speed installation of the SE keypad, holes have been spotted on the inside the back housing for mounting to a wall or a single-gang electrical box.By default (auto-entry is off), all codes must be followed by the key. The master code allows access to programming mode and activates the main relay. 1 The master code is always stored in user location 1. For use in extreme weather conditions, consult the factory for additional methods of protecting your keypad. DoorGard Command and Control keypads are factory programmed with a master code of 1234.This allows air to circulate and a place for condensation to drain. 1. Do not seal the drain holes at the bottom of the keypad housing. Do not silicone the cover plate because the unit will not seal properly. This helps prevent water from entering the case and condensing on the circuit board. The housing has been designed to mount directly on a. There is an internal sounder that is used to indicate key press feedback, and a bi-color LED to indicate operation. IEI Linear Corp IEI 212i Style Flush Mount Indoor Keypad (0-211111) 212i - 0-211111. The sealed environment 212SE style keypad features a brushed metal housing that has been treated to resist corrosion and an all metal Braille, alpha-numeric keypad. When mounting this unit outside, apply silicone to the area where the wires enter the case. This item: IEI International Electronics 212W Membrane Keypad.The bi-color LED provided with the SE keypad illuminates red when the LockRelease relay is de-energized and green when the relay is de-energized.To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |